Agricultural Chains manufacturers

Blog Forums Zmiany w prawie oświatowym Agricultural Chains manufacturers

This topic contains 0 replies, has 1 voice, and was last updated by  hellokittyki 1 month, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #66228

    hellokittyki
    Participant

    ● ASME/ANSI Stainless Steel Roller Chain
    ● ASME/ANSI Nickel Plated Roller Chain
    ● British Standard Roller Chain
    ● Non-Standard Roller Chain
    ● 81X Conveyor Chain
    ● Welded Steel Chain
    ● ASME/ANSI Rollerless Chain
    ● Combination Chain
    ● Caterpillar Chain
    ● Drop Forged Rivetless Chain
    Another technology that is sometimes used on combines is a continuously variable transmission. This allows the ground speed of the machine to be varied while maintaining a constant engine and threshing speed. It is desirable to keep the threshing speed constant since the machine will typically have been adjusted to operate best at a certain speed.
    Self-propelled combines started with standard manual transmissions that provided one speed based on input rpm. Deficiencies were noted and in the early 1950s combines were equipped with what John Deere called the „Variable Speed Drive”. This was simply a variable width sheave controlled by spring and hydraulic pressures. This sheave was attached to the input shaft of the transmission. A standard 4 speed manual transmission was still used in this drive system. The operator would select a gear, typically 3rd. An extra control was provided to the operator to allow him to speed up and slow down the machine within the limits provided by the variable speed drive system. By decreasing the width of the sheave on the input shaft of the transmission, the belt would ride higher in the groove. This slowed the rotating speed on the input shaft of the transmission, thus slowing the ground speed for that gear. A clutch was still provided to allow the operator to stop the machine and change transmission gears.
    Later, as hydraulic technology improved, hydrostatic transmissions were introduced by Versatile Mfg for use on swathers but later this technology was applied to combines as well. This drive retained the 4 speed manual transmission as before, but this time used a system of hydraulic pumps and motors to drive the input shaft of the transmission. This system is called a Hydrostatic drive system. The engine turns the hydraulic pump capable of pressures up to 4,000 psi (30 MPa). This pressure is then directed to the hydraulic motor that is connected to the input shaft of the transmission. The operator is provided with a lever in the cab that allows for the control of the hydraulic motor’s ability to use the energy provided by the pump. By adjusting the swash plate in the motor, the stroke of its pistons are changed. If the swash plate is set to neutral, the pistons do not move in their bores and no rotation is allowed, thus the machine does not move. By moving the lever, the swash plate moves its attached pistons forward, thus allowing them to move within the bore and causing the motor to turn. This provides an infinitely variable speed control from 0 ground speed to what ever the maximum speed is allowed by the gear selection of the transmission. The standard clutch was removed from this drive system as it was no longer needed.Agricultural Chains manufacturers
    website:http://www.drivingchains.com/chains/agricultural-chains/

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.